sundance-communications.com/forum Forums General General Telephone & Systems Information DSL filter adapters.

I am looking for something that may not exist.

looking for a 66 block(enough for 2 - 6 pair) with rj11 jack built in that filters on side for DSL. Should be small easily mountable, and inexpensive.

End Result : Xconnect to "in" spades of 66 block. Xconnect "out filtered" on 66-block
Xconnect "out non filtered" on 66 block.
Also baybe have the RJll equals built in for combination connections.

Found the Suttle 649A-1. similar, but they are rather large, have screw downs, and are about $30.00.

[This message has been edited by BillFlippen (edited September 15, 2005).]

We use a splitter and enclosure made by Keptel. LPF-200 and TA-230. This is a little smaller about 4x4" and yup I think they are around $30. These also have binding posts. Simply mount one of these to your backboard and use some cross connect wire to connect it to your blocks however you want. DSL gets taken off before it and voice after it. What's wrong with that?

Can't see what your contraption would be good for.

-Hal