sundance-communications.com/forum Forums TDM Business Telephone Systems Avaya - Lucent Telephones & Systems Pagepal question

Hi i have a Pagepal 6 for my merlin legend, and my question is can you hook up the speakers to the pagepal or have to get a amp?


Thank you

pagepal 6 is aamp with zones & talk back, not very powerful , you need to be careul of what speakers you use no 70V speakers, look on the rear of the unit ,will tell you everything

I'm not sure there was a Pagepal, how about Pagepac 6?

If so it is one zone one way, just a basic paging amp. The "6" stands for 6 watts. I don't think the output impedance will tolerate much below 4 ohms so that means at most a couple of 8 ohm speakers at 3 watts each.

The speakers provided for this amp are actually 70 volt speakers. Because of the high impedance taps on the transformers you can use up to 18 though don't expect an awful lot of volume from them.

If you need more power you can use any PA amplifier with a line level input instead of the Pagepac. You wouldn't use the Pagepac at all, the PA amp would conect to the page port of your Legend and the speakers would connect to the PA amp.

-Hal

sorry it is a pagepac 6+ that has 3 zones & talk back , the pagepac 6 was single zone

PagePal is basically a UPAM, with the addition of Night Ring. It is the interface to take a Trunk port from a Legend, provide talk battery to the switch and 600-ohm output to connect to the input of an amp.