sundance-communications.com/forum Forums TDM Business Telephone Systems Avaya - Lucent Telephones & Systems Partner R7 Paging

I replaced an old NEC with a new Partner R7, everthing went ok till I got to the paging . I replaced an old Radio shack amp with a Bogan TPU-100B . First I mounted a TAM-B unit , I wired power supply punching to a161D PS (PRSLSI ) 24VDC 35mA ,next I wired phone system T&R to line port 5 on partner (moving all lins down 1) next output( PT&PR ) to punching 5&6 on amp Marked tel. I hooked the speakers up the same as the old amp (com -16 omhs) programed a button ( IC *70) nothing (denial tone) did I forget something? :bang:

Did you program line 05 as the page port. It's just int 70 no * unless you assign a group of phones with it in group calling.

You have to program line 5 as paging port(Com. #617)

You don't need the TAM-B at all. I would take it out of the equation all together.

*70 is sumultaneous page, and it won't work if there are no extensions in Group 1 (71). Intercom 70 is Loudspeaker Only Page

You can use ANY line port, but you must program it in #617

If you use Line 5, you will get a contact closure across the Black and Yellow during the page, which you might need for music mute.

Does your version of TPU-100 include a 4-C jack in the section with the input terminals? If so, use line 5 and a 4-conductor line cord from the Partner to the Bogen to connect. If not, Green and Red are the Tel In, and Black and Yellow are the Music Mute, OR, you can permanently strap the music mute, just use the audio, and then you don't need to use CO5