|
|
Joined: Nov 2004
Posts: 149
Member
|
OP
Member
Joined: Nov 2004
Posts: 149 |
we're adding 2 800 mxl modules and a carrier to an existing legend r3. will the system recognize the new cards and assign extension numbers, or do i need to do a board renumber and then reprog the ports back to their previous ext numbers?
as long as i'm bugging you, what are the pin outs of the admin jack to use the spm program?
much appreciated rich
"It's like the man said...never take life too seriously, you'll never get out of it alive" Bugs Bunny
|
|
|
|
Joined: Feb 2007
Posts: 2,473
Member
|
Member
Joined: Feb 2007
Posts: 2,473 |
Rich, System will recognized new cabinet and cards and assign extensions numbers. You don't need board renumbering but even if you do it's not going to change your numbering plan. I am just wonder why you need pin out for Admin port. It's a regular strait through CA5.
|
|
|
|
Joined: Feb 2005
Posts: 12,342 Likes: 3
Member
|
Member
Joined: Feb 2005
Posts: 12,342 Likes: 3 |
Going to need a 355A no? You can use a regular patch cord. Tradition calls for a D8W line cord.
-Hal
CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
|
|
|
|
Joined: Nov 2004
Posts: 149
Member
|
OP
Member
Joined: Nov 2004
Posts: 149 |
thanks vad, i was hoping i wasn't going to need to do that. their old tech did all his moves by renumbering ports, so ext numbers are all over he place. i was trying to make a rj45/db9 hood to plug the ca5 into my serial port, but i think i found it in an earlier post.
thanks again rich
"It's like the man said...never take life too seriously, you'll never get out of it alive" Bugs Bunny
|
|
|
Forums84
Topics94,262
Posts638,697
Members49,757
|
Most Online5,661 May 23rd, 2018
|
|
|
|
|