|
|
|
|
Joined: Apr 2005
Posts: 309 Likes: 1
Member
|
|
Member
Joined: Apr 2005
Posts: 309 Likes: 1 |
I just installed a PRI T1 with an Adtran that converts it to E&M wink to an Avaya G3siV4+m. The system parameter ISDN-PRI is n. With the same setup to a Rolm 9751 we do get Caller ID. I wonder if there's a system parameter or setting within the trunk group that will allow this. When I look st the D-Channel log in the Adtran I see all the CID data coming in.
|
|
|
|
|
Joined: Sep 2005
Posts: 898
RIP Moderator-General
|
|
RIP Moderator-General
Joined: Sep 2005
Posts: 898 |
Without ISDN-PRI set you y your not going to get cwid as far as I know...your best bet is to get a hold of avaya tier3 on this site and talk to him he might be able to help you out...he's pretty [email protected]
Bob Wells
WellComm, Inc.
"As long as nobody's dead or in jail, it can't be all that bad ! "
|
|
|
|
|
Joined: Dec 2008
Posts: 41
Member
|
|
Member
Joined: Dec 2008
Posts: 41 |
Not sure what load this was added. I would guess v4 7.0 or 8.0
page 2 of trunk-group form for tie trunk
If this field is there, you can change it and get CID on a PRI with Adtran that converts to common channel or robbed-bit tie
Incoming Tone (DTMF) ANI: *ANI*DNIS*
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers" bsh 36 years Bell, AT&T, Lucent, Avaya Tier 3 for 26 years and counting http://bshtele.com
|
|
|
|
|
Joined: Apr 2005
Posts: 309 Likes: 1
Member
|
|
Member
Joined: Apr 2005
Posts: 309 Likes: 1 |
Thanks - I'll check to see that field is there.
|
|
|
|
Forums84
Topics94,515
Posts639,961
Members49,847
| |
Most Online5,661
May 23rd, 2018
|
|
|
0 members (),
155
guests, and
32
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
