Hello,
Could someone please help on this I am really dissapointed..how can I set a station group that is set to accept calls from 709 - 716 ( two isdn bri ) to send the correct clip outgoing number and not dial an outside line from other trunks and therefore send another clip?
I have set on 614 the stations to group 006 and trunk groups 709 - 716 to group 306, then on 304 I set 006 to use 306 but it is not keeping the configuration.. when I press mmc 304 again the station group 006 is using 301 (the default). is any other command that overrides this clip configuration. is any other setting where you use the 614 groups assignment?I have tried mmc 323, ( no success) I cannot send the correct clip..any help would be deeply appreciated.
Thank you

The ext-trunk tables are by default all set to yes.

You need to change your station group to dial no for the other trunk groups, and only have the trunk group you want them to use set to yes.

You will also need to make the other groups no for this trunk group.

Put all trunks in the 0 (or 9) trunk group.

You'll also need to make sure you program the cli against those phones, and set the bri lines to use the correct cli table