I have an OS7030 with no RUN light. I checked the voltages off the PSU and the 5v, 12v, and -54v rails are all good, although 5v was a volt low but that isn't going to kill it. when I plug in the LAN cable that LED lights so it seems to be alive. Is there anything I can try to bring this back to life? I have an electronics repair background so I can troubleshoot, but it seems like something weird is going on here.
Do the phones have anything on the display? Could it be the bad file system and the software was never upgraded?
The phone is just stuck at VER V2.2 2003 4.30. Hooking up my serial cable to the 3 pin header gives no output.
Do the phones have anything on the display? Could it be the bad file system and the software was never upgraded?
It sounds like it is bricked.This isn't the same 7030 as your other thread?
You mentioned the 5V line, what's the reading?
No, different one. That OS7030 hasn't been sent back here yet for repair.
It sounds like it's bricked
So not a fixable issue? Just need to verify before I bin it....
It sounds like it's bricked
Have you tried the recovery procedure on it? My guess is it needs to be recovered or you have a bad power supply.
So not a fixable issue? Just need to verify before I bin it....
It sounds like it's bricked
4V seems a little low I would guess power supply
I don't know the tolerance on the 7030, but the idcs100 didn't work with anything lower than about 4.8v on the 5v rail.
Checked it again and it's actually 5v. So it must be a full brick. No response from putty, and no run light at all.
4V seems a little low I would guess power supply
So if you boot it up, you get nothing from the sio port?
Nope, just sits there. No output to putty.
Never used Putty do you have hyperterminal at all? What do you use for an SVMi?
I have used both for recovering systems. Putty and hyperterminal are the same essentially, putty also works on SVMi. This one is just bricked. I sent it out to telesource to see if they can attempt to repair it. If not, they will scrap it and it will be no charge.