|
|
Joined: Apr 2010
Posts: 7
Member
|
OP
Member
Joined: Apr 2010
Posts: 7 |
Hi All, Well I feel I should post the outcome of my endevors with this system. I was able to get all 24 TEL ports working finally by taking Rickman's suggestion of removing the ESI(8), setting it's slot to NON in MB 7-1 then reinstalling it in slot 5 and adding it back in to MB 7-1.
I did make one key mistake. Apparently one of the ports that I thought was not working by measuring it's output voltage was in fact OK. The wall jack I had installed for this phone was open. You can't test the port without a phone connected otherwise the T/R output just goes to +5v on tip and -24 on ring. Opps.
I am getting an MIFM board so I can back the system up. Also would like to upgrade to a higher capacity unit that would allow me to reuse the ETUs and phones...IPKII perhaps.
Thanks, Ike
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
Forums84
Topics94,291
Posts638,815
Members49,767
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
148
guests, and
398
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|