Does anyone have information on setting up a VLAN on the 200 ICP. It is a new install running 1.1.0.16 into an HP Procurve switch. I set it up the same as if it were on a 3300, but when I connect the 200 to the HP I cant get any phone to come up. The port for the 200 is set for VLAN 2 and is set for untagged. The ports for the phones are set for tagged. If I plug the 200 into a port that is set for the default VLAN I can ping it with a PC connected to the HP. But when I move the 200 to the untagged port I can no longer ping it from my PC. I have verified the IP address's of all the components and they are all on the same subnet. If I plug a set straight into the 200 the set boots up fine. If anyone has any insight it would be greatly appreciated.