<font face="Verdana, Arial" size="2">Originally posted by BillFlippen:
Encountered a small DBS System. One extension was a slow flashing MW light. Steps to clear the MW light would not clear it. Possibly something else going on?
Also Can names be entered through Telco PRogramming? Could not get any Alpha to display only Numbers.
When Programming the Vmail Xfer button I needed V60# could only enter V60# (probally relates to text entering)
Finally, I figured this ouut but should it be this way. CO comes in. There is an Extension list that is supposed to ring. After 2 rings call goes to main greeting of VM. When I bumped it up to 4 rings (24 sec)calls went after 3 rings (20 sec) to individual mailboxes. Changed the extension call forward timer higher than the CO then things work fine. Is it true that the Extension CFWD overrides the CO call forward?</font>
MSG light: Dial off code "auto flash" UP TO 4 TIMES to clear light
Names:From port 1 dial Prog#2. enter port number(2 or 3 digits depending on system)
VM Trans: PROG,(touch button)CONF,AUTO,AUTO,Pilot number, additional digits,HOLD. If you get error tone, you need upgraded CPC card or firmware
