Quote
<font face="Verdana, Arial" size="2">Originally posted by MrGemini:
I'll bet whan you answer the call you hear
"you have a call".
You need to have the TVS set up for a blind transfer.
Go into the TVS with the laptop.
1 program, 6 hardware settings, 3 PBX interface parameters, 1 dialing parameters.
Add an "A" to the transfer sequence so it reads FXA
Are you sure there is an A after the P ?
P401A******A would be a version or -1

[This message has been edited by MrGemini (edited May 16, 2005).]</font>

I set all three transfer types to FXA.

When a call is transferred from the custom service, I see the voice mail port # on the phone's display until I pick up the phone.
Then I see the Caller ID info.


[This message has been edited by fpgaguy (edited May 16, 2005).]