Hello all,
I have a client who is replacing a 56k data circuit with a point to point T1. Verizon has decided they're not going to offer 56k anymore, and thus people must be migrated.

We had a DSU-5600 on each end of the old circuit translating the data. Now we've put in two Kentrox Datasmart Add/Drop units to handle it.

Here's where I ran into a wall:
The data has to be changed from b8zs/esf to 56k to serial before it can be put into the transmitting device.

Well, actually, from the originating point:

serial->56k->b8zs/esf- across the point to point circuit- then b8zs/esf->56k->serial

Right?

My question is this.
How do I pin out a connector from the db25F on the back of the Kentrox to the rj45 on the back of the Adtran DSU-5600 properly?

I'm looking at all of the manuals I can find, and nothing matches up.

Thanks to anyone who can help me decipher this,
tylerpd1

If you can read this, you're in range.