Ive been working on a Dx80 Allll day long. Its software version is F39 and of what I understand is its already discontinued(after a few months). The setup is quite simple: 2 hunt groups(HG#6,415 and HG 24,433)Well 5 co lines are programmed to ring 415 then go to auto attendant(box 800).Then the caller gets transfered to the designated ext. If no one is there the Mailbox picks up. Well this is what happens: It rings, all the exts that are supposed to ring light up, then they stop ringing ( at this point is when I think its going to auto attendant but it is still ringing on my phone) and it rings for about 50 more seconds then finally the auto attendant comes on. It goes through its speel and I get transferred to an extension. But just rings ther for about 10 seconds then it stops ringing at the phone but is still ringing on my end.Again for about 50 more seconds.Then instead of getting the mailbox I get the darn Auto atendant again. And thats not the end of it. On several occations I get no AA, it just rings forever. then i go and try to dial direct 433 and it says no valid member.So I go into programming, check the UCD 24 and all the members (157,58,59,60,) are no longer there. Anyone got input? Thanx