I recently picked up a used iDCS 100 off ebay to use in troubleshooting one of my locations. Maybe I can get some help on both problems.
1. The existing box, if you power cycle it and have the Ethernet connection plugged into the MCP1, it hangs on boot. I have replaced the processor and the power supply.

2. On the switch I just bought to use for board swaps, the person I purchased it from did not default it and the tech passcode is not the default. I have pulled the MCP 1 card, switched the switch off and left it that way for 30 minutes. When I put the card back in it still had it's programming. I have heard mention of a back door to override this. Any suggestions? I ave a digital phone hooked to it.



Thanks in advance,
Ken