Just look at your original cabinet layout on card layout in pcpro. It will give ports on the cards. Remember, on the NEC the program overlays the port layout. You need to install the cards and get the port order the same as the program and all will be well. You really don't need to upload to a demo system and in fact it probably boned you. Pull all the cards save the first digital station card next to processor (you have to have this on Aspire), load the original database and look at the card config and start inserting the cards to make them come up in the proper order. This is literally what you have to do as I have done hundreds of these in the past. If you can't figure this out or understand it you might need to get a tech in.

PALB should be a max system.

Last edited by Coral Tech; 02/14/23 09:41 AM.
Coral Tech
www.pantelonline.com