sundance-communications.com/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems Caller id on sx200 icp with t1

I would like to add something here, only 9 channels ( 10-18) are used on this t1 circuit

I do believe the delay is from the ani timeout. Turn it off in the trunk cos to verify.

I'm going to bet that you're not receiving ani on your trunks. If you take johnp's advice, and turn off the ani cos option, you should see *ani*dnis on the incoming call records, and the call will not route properly.

i tried turning off ani in cos but left smdr record ani/dnis on, that does make incoming calls to ring immediately but i still dont see ANI/DNIS on incoming call records.I am currently onsite & trying reach a human on AT&T Tech Support from past 35 mins.

I believe will not receive CID on a T-1 Inbound- CID on T-1 is outbound only and that is provisioned by the carrier. The only ANI DNIS digits you will recieve on a T-1 are any DID #'s being sent by the carrier ( viewed by turning on incoming SMDR )and that is only if the circuit is configured that way.

If your circuit is in the MMC and you are using a E&M circuit discriptor. You have a T-1 and in my experience you will not receieve inbound CID, You will need to convert the circuit to a PRI

Wait a minute, Alex. Didn't I say that 5 posts back? Guess that proves that all great minds think the same way.

Lightninghorse, yes you did. I was always told great minds run in the same gutter in this business. LOL

Alex

I'm 'rarely' arguementative, but I know of 3 or 4 systems that are receiving caller ID on plain old T1 circuits.
The calls come in as '*ani*dnis'(DTMF format), and the caller id displays on the digital phones. You may not be able to order NEW circuits that way, but they were available at one time!
As a matter of fact, Mitel has been offering that feature since G1005, which was way before PRI cards were around

I too have several sites receiving ANI/DNIS on T1 circuits. As long as the carrier adheres to the US Sprint standard as above *ani*dnis, it works for number delivery. That being said, I can't say AT&T will or will not work.

fifty5footer & johnp, Good comments! When I went to Mitel school in NJ on the 1005/1006, lite15/16, we were told that ONLY Sprint and MCI were offering ANI/DNIS on T1. That WAS about 13 years ago, when that TWA flight (800?) went into the drink off the east coast. And, like you, I have no idea if AT&T is offering it now.
Alex, :rofl: