Trying to get to the bottom of this!

Print Thread

Rate Thread

Trying to get to the bottom of this! #122347 11/19/04 05:03 AM
Joined: May 2004 Posts: 335 Simi Valley, CA, U.S.A. Jack Damage Member
Jack Damage Member Joined: May 2004 Posts: 335 Simi Valley, CA, U.S.A.	I read the manual that in order to access a CAll Pilot via LAN, you must use Explorer version at least 4.0, but less than 6.0. I cannot connect to any CP. All my PC's have Explorer version 6.(something). I have read here on this board that the version doesn't matter above 4.0 . I need to edit some COS for a few customers and I'm getting nowhere. Can someone tell me specifically (crossover cable?, IP stteings, etc...)how to accomplish this???? Please!!!!!!!!!!!!!!THX Punch down all your damn pairs!..........(please).

Nortel Phone System Service

Nortel Phone System Service in Canada

Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.

Re: Trying to get to the bottom of this! #122348 11/20/04 05:21 AM
Joined: Aug 2004 Posts: 1,747 Likes: 49 Calgary, AB, Canada Toner Admin
Toner Admin Joined: Aug 2004 Posts: 1,747 Likes: 49 Calgary, AB, Canada	Yes, you need a crossover cable if you are connecting directly to the CP. You will also need to make the IP address of your PC similar to the IP address of the CP. For example, if the Call Pilot is 192.168.1.100 you should make your PC 192.168.1.101 with a subnet mask of 255.255.255.0 Looking for a VoIP Phone Canada provider? Put Atcom's valuable VoIP expertise to work for your business today!

Moderated by MooreTel

Hop To

Link Copied to Clipboard

sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems Trying to get to the bottom of this!