Nortel CICS won't initialize

Print Thread

Rate Thread

Nortel CICS won't initialize #129847 09/08/06 07:31 AM
Joined: Sep 2006 Posts: 8 Bayville NJ Fred Stetter Member
Fred Stetter Member Joined: Sep 2006 Posts: 8 Bayville NJ	I have an older Norstar CICS 4X16 that was powered down and unused for over a year (supposedly worked before then) When I powered it up the system won't initialize. All I get is steady blinking lights all sets. Tried reseating the line module and memory card but still n/g. I do primarily Partner ACS systems and have very little Norstar experience. Any ideas? Thanks....Fred

Nortel Phone System Service

Nortel Phone System Service in Canada

Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.

Re: Nortel CICS won't initialize #129848 09/08/06 08:24 AM
Joined: Apr 2005 Posts: 194 Chino Hills, CA, 91709 gamedinasr Member
gamedinasr Member Joined: Apr 2005 Posts: 194 Chino Hills, CA, 91709	Normally the system will come up after a few minutes, if all it does is constantly blink your system is defective.

Re: Nortel CICS won't initialize #129849 09/08/06 08:36 AM
Joined: Nov 2004 Posts: 222 FL JimmyT Member
JimmyT Member Joined: Nov 2004 Posts: 222 FL	what is the software level that you are trying in it?

Re: Nortel CICS won't initialize #129850 09/08/06 09:44 AM
Joined: Oct 2005 Posts: 4,685 Likes: 4 Ottawa, ON. Canada telemarv Member
telemarv Member Joined: Oct 2005 Posts: 4,685 Likes: 4 Ottawa, ON. Canada	Is this the orginal software from when it was stored? Marv CCNA, CTUB TeleMarv Services (Retired) Providing telecommunication solutions in Ottawa Canada since 1990

Moderated by MooreTel

Hop To

Link Copied to Clipboard

sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems Nortel CICS won't initialize