atcomsystems.ca/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems Programming 1100 IP Expansion module

Having a problem programming lines to an expansion module for the 1100 phones. Here are the details. BCM 400 running version 4.0.2.03, using 1140E IP phone. I have added two 1100 series expansion modules to one of the phone and one module to another phone. Power the phone up and it is normal. The modules power on and stay lit, but show what appears to be rev information? Feature *0 on the phone, and when I press a button on the addon, the phone shows nothing as if a button was not pressed. In the phone system I have both DN's assigned as a CAP. Is there something that needs to be done to get the system to see the addons? Following the manula, there is supposed to be a CAP/KIM button in Capabilities for that DN, but there is not on my BCM? Any help would be much appreciated!

You can try F*1, Press button and assign number.

Kem modules are not supported on the 11xx series phones in bcm(50 or 400) there was supposed to be a patch but nothing so far.