|
|
|
|
Joined: Mar 2008
Posts: 9
Member
|
|
Member
Joined: Mar 2008
Posts: 9 |
I'm installing my first PRI on a Nortel MICS. I got the PRI enabler and have put it in. I'm a little confused as to what needs to be enabled in the maintenance part and the hardware part of the programming. Can anyone help? Also, the PRI card is flashing green. Is this because the numbers haven't been ported? Or is this something else? Thanks in advance.
|
|
|
Nortel Phone System Service in Canada
Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.
|
|
|
|
Joined: Apr 2001
Posts: 1,390
Member
|
|
Member
Joined: Apr 2001
Posts: 1,390 |
Same thing that probably needs to be programmed on any NEC systems with a PRI interface.
Config integrated CSU, unless using external, to match telco settings.
DID and target lines (rcv'd digits)
Ascending?
Protocol? NI2?
A few others, which i cant think of.
Just thought of it.
Routes and dest codes.
that's about it.
|
|
|
|
|
Joined: Dec 2003
Posts: 2,086
Former Moderator-Nortel
|
|
Former Moderator-Nortel
Joined: Dec 2003
Posts: 2,086 |
Make sure that you program the card as a PRI in hardware, then power off and reboot.
Numbers not ported have nothing to do with the green light. That green light flashing just means that it is not sync'd up with the smart card (circuit). I have seen some smart jacks that need a straight cable and some need a cross-over. Check all other programming needed for PRI.
If CON is the opposite of PRO
Then what is the opposite of Progress?
|
|
|
|
|
Joined: Dec 2004
Posts: 38
Member
|
|
Member
Joined: Dec 2004
Posts: 38 |
Also build PRI pool and have extensions capable of accessing this pool. Is this a fragmented T. If so disable the B channels that aren't used. Set them to "far" paramater. Is this 10 digit dial? Nortel default is 7. Change this if needed. Delete external code of 9 and then build destination code "9 and any" delete 1 digit and route codes.
|
|
|
|
|
Joined: Feb 2007
Posts: 2,473
Member
|
|
Member
Joined: Feb 2007
Posts: 2,473 |
As NTlayoff said: First set that card as aPRI in Hardware, usually the default its all you need, then go to Maintenance, Disable card and then Enable it again. Go Lines and assign Lines to PRI-A Pool.
Next delete access code 9 and go to Service> Routing> Destination code> Add 9> follow by Any digits and choose Rout 001 w/PRI-A Pool
|
|
|
|
Forums84
Topics94,524
Posts640,007
Members49,852
| |
Most Online5,661
May 23rd, 2018
|
|
|
0 members (),
173
guests, and
56
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
