sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems CTE

Has anyone setup a BCM with Maximizer?

I guess not Larry. Should be a peice of cake.
Install your CTE keycode first, then set up the client ID and password for use with the CTE code.
Install the software and configure it.

That sounds simple enough especially for someone who has never done it before.

Is that similar to:
How to replace a car engine.
Remove old engine.
Install new engine.
Turn key to start.
It's a piece of cake.

Sorry Larry - never done a Maximizer before.

NT are you being mean spirited today?

No - it wasn't meant to be mean-spirited.

When I read your post, all of the past images of people who told me, "All you have to do is xxxxx...... It's a piece of cake." then I remember days later still trying to finish or fix or get working whatever the project was.

But when you post that you had never set up Maximizer either, but yet said, "It's a piece of cake." it came across as patronizing.

Ok, I see you point. I was trying to encourage him. Sometimes a piece of cake turns into one hell of tough job. Would be fun to try and make it work.

After so many days and 2 questions, I didn't think I would get an answer. Sounds simple enough except maximizer needs to go out through TAPI.

You must use a CTE keycode to enable TAPI. The BCM50 must be on your network. Under applications in element manager you will find the settings for CTE.