sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems Odd BCM 400

This is sort of convoluted but here goes.

@ bcm400 at 1 site tied together with Sip trunks.

PRI into box 1 and all digital stations.

Analog stations fill up box(or BCM )2. No lines but Voip trunks in this box.

How do I point a DID # to an analog fax on box 2? I have looked through all the target lines and don't find my numbers. This is working on several other extensions, but I can't find those target lines either in box 1. These are just analog room phones. For example ext 2445 is in box 2, I can call 2445 or 8262445 and it rings just fine, but I can not find 8262445 associated with any target line in box 1 where the PRI is. This is on a system that was working this way until it lost a harddrive.

Also, how do I get from box 2 analog stations to the PRI pool for outbound calling?

Hope this makes sense.

Are the lines redirected to the analog extension numbers (line redirect feature code)?

I think you have to create a route that points to the VoIP trunk for any extension number on the other side. You'll also have to create a target line with the extension number as the "Private Received Digits" for the BCM with analog phones.

The outbound calling should already be setup as long as the phones have access to the correct line pool (VoIP trunk).

Shouldn't there be a target line for each of the did numbers that ring into the second box? I looked through all the target lines and can't seem to see them in there.

The phones have access to the pool with the voip trunks in them, but I get a fast busy when I dial. I guess i need to check the access code for this pool.

Yes, there should be target lines with the Public Received Number in BCM A, and target lines with the DN as the Private Received Number in BCM B.

There should be some routing info that might help under the setup of the SIP trunk itself.