BCM 400 r4 Analog static issue

Print Thread

Rate Thread

BCM 400 r4 Analog static issue #149305 07/24/11 09:14 AM
Joined: Dec 2005 Posts: 5 Texas byronchaplin Member
byronchaplin Member Joined: Dec 2005 Posts: 5 Texas	Talk about frustrating; inbound via PRI, "garbled" static on 2 analog ports, seperate modules (1 base, 1 exp), rebooted, replaced gasm w/ known good one & prob. still occurrs. Port 2 on base gasm8, port 3 on exp gasm8. Any ideas? Have reset system 3x & replaced gasm8 to no avail. Verified amp connections to module & tried all known tests.... :bang:

Nortel Phone System Service

Nortel Phone System Service in Canada

Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.

Re: BCM 400 r4 Analog static issue #149306 08/17/11 10:19 AM
Joined: Aug 2004 Posts: 1,747 Likes: 49 Calgary, AB, Canada Toner Admin
Toner Admin Joined: Aug 2004 Posts: 1,747 Likes: 49 Calgary, AB, Canada	I'm sure this comment is too late, but is there any chance the PRI timing is set to MASTER instead of SLAVE/NORMAL? Looking for a VoIP Phone Canada provider? Put Atcom's valuable VoIP expertise to work for your business today!

Re: BCM 400 r4 Analog static issue #149307 08/17/11 10:35 AM
Joined: Dec 2005 Posts: 5 Texas byronchaplin Member
byronchaplin Member Joined: Dec 2005 Posts: 5 Texas	No, not too late - issue still persists. Thanks for the reply! Just double-checked the clocking and it is set to External.

Moderated by MooreTel

Hop To

Link Copied to Clipboard

sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems BCM 400 r4 Analog static issue