atcomsystems.ca/forum Forums TDM Business Telephone Systems Toshiba Telephones & Systems Night/Day Programming On A Strata DK424

I've just been put in charge of finding out how to program our Night button. Currently it transfers to one extention when the Night mode is enabled, and I'm trying to figure out how to change the extention it rings to. I would also like to have it ring the page system after a certain amount of time.

After a fair bit of research, I think I have a plan on how to acheive this.
My problem seems to be, I can't figure out where to plug in the phone [DKT2020-SD]. I have pictures of the cabinet that I can provide.

Also, I think I want to program 77-3 for the ringing over the intercom. Is this correct?

Thank you for any help in advance!

You must program from port 005 , usually X-205 . It is porgram 78 where you program ringing oner paging and the system must be in night mode for it to ring over the paging. As far as changing the extension that rings in night mode , if you are using POTS lines then program 87.

Ok guys, I'm gonna have to step in here and put a stop to this. There's too much information given out about how to get into programming. The responses so far are as clear as it's going to get. Your original post was about day/night mode, but it's turned into how to get into programming which is an entirely different subject. A subject that will not be discussed in detail in this open forum. I have deleted all posts regarding how to get into programming and/or anything off the subject and have PM'd the OP with specific details on how to get into programming. At this point on, please stay on subject.