sundance-communications.com/forum Forums TDM Business Telephone Systems Toshiba Telephones & Systems paging over QSIG

hi guy's,,,i have configured two system with qsig, over a local lan, everythings coing fine,
but i need both system to page over each other.
i created each felx access code, 82 & 83, put config in prg, 670, 674, 651,671&672, but when i dial the acces code 82, i have external line hangup,,no remote dialtone,,,can you help
thank's

Dial the node id plus the page code.

tried 82#30, external line busy,,,& busy tone, i suppose to have the dial tone of remote node.
even 82+ 9, give me the local dial tone.

What feature have you set the code 82 and 83 to in the flexible access codes?
You should be dialling the Node ID number and then the feature code for the paging eg #30 for all call page or #31 01 for zone 1

flex access code 82-network acces code for remote node, same for 83,,in each system, it'S very easy but not working??? qsig is full operational ,, i will try an other acces code,,or just the 2+#30..thanks

Add a flexible access code on each system as follows:

Node 82: add 850 and set it for All Call Page
Node 83: add 860 and set it for All Call Page

Add 850 and 860 in your NETWORK DN database and set 850 and 860 for their respective nodes.

Now all you will have to do is dial 850 or 860 to page over Qsig.

I always had issues with paging... I think it was the # that the system didnt like.

This always works for me. Good luck with it.

i tested in node 2 (node id),,the 888 give the local node paging system.
82 is access 82 to remote node, for taking the dial tone & line from there to make calls,,

other node is 3, from there access 83 to remote node, to do paging,,,but no luck,,,it's supposed to work,, i know i'm close to the solution,,,can you help?
thanks

Your node ID's are 2 and 3?

i have solved the issue, in prg 656, node id, i have put the local syswtem 82 & 83 net access codes in each system. works in a minutes.