sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems Nec Elite voice mail

On this VM when an incomming DID call comes in their is no greeting heard. But, if you call internally you do get the greeting. Is ther two greetings you need to record? Also, what is the mail box type for longer message length?

Thanks

the message length can be changed in each mailbox.


as for the did stuff it should go to that persons mailbox

ok looked in the features & specs manual:

If a DID incoming call is not answered before a time specified in Memory
Block 1-1-07 (Tie Line Delay Ringing Time Selection) (default: ¥, no
timeout), the call can switch to normal Day or Night ringing assignment.

If the number of DID incoming calls is not over the limit, and DID
Forward Station Number for Busy Station or Undefined Digit is active,
forwarding is activated.

Incoming calls on DID lines follow Call Forward and Station Hunting.

lenght of message in mb can be changed in the system programming persay the class of service, or is this achieved through the vm
programming?

In 1-2-22/1-1-22 when i assigned the did to the port dit day/nght, it worked, but the vm dose not pick up accordlingly from outside to in. When I calll insisde to inside vm grabs after 4 rings? did I miss something?

Thanks for the quick help!

length of the message is controlled by the vm. so you'd have to get into the vm programming for that (cosessions).

1-2-22 is the timer setting for the no answer (system wide setting)

1-1-22 is the did conversion tables. this is where you tell the system what digits you receive will go to a specified station.

here's a list of all the programs dealing with DID's:

Card Interface Slot Assignment 7-1
Trunk-to-Trunk Group Assignment 3-03
Trunk Type Selection 3-91
Tie Line Type Assignment 3-14
Tie Line First Ring Pattern Selection 1-1-34
Tie Line Delay Ring Pattern Selection 1-1-53
DID Line Ringing Pattern Selection 1-1-55
Tie Line Prepause Time Selection 3-16
Tie Line Wink/Delay Signal Detect Timeout Selection 3-25
Tie Line Answer Detect Time Selection 3-17
Tie Line Delay Ringing Time Selection 1-1-07
Tie Line Release Detect Time Selection 3-18
Tie Line Length of Wink Signal Selection 3-21
Tie Line Length of Delay Signal Selection 3-22
Tie Line Send Tone Selection 3-27
Tie Line Reorder Tone Selection 3-28
Digit Add/Del for Tie Line Networking Assignment 5-00
DID Digit Length Selection 1-1-20
DID Forward Station Number for Busy or Undefined Digit 1-1-23
DID Digit Conversion Assignment 1-1-21
DID Digit Conversion Table 1-1-22
Class of Service (Station) Feature Selection 2 1-8-08=4-3,4-4,5-7
Station to Class of Service Feature Assignment 4-17
DID Limit to Tenant Assignment 2-09
Trunk to Tenant Assignment 2-01
Line Key Selection 2-05
Line Key Selection for Tenant Mode 2-06
Line Key Selection for Telephone Mode 4-12
Telephone to Tenant Assignment 4-09
CO/PBX Ring Assignment (Day Mode) 4-01
CO/PBX Ring Assignment (Night Mode) 4-02
Extension Line Key Ring Assignment (Day Mode) 4-37
Extension Line Key Ring Assignment (Night Mode) 4-38

Thanks chrisleback. One question, do I have to program the message length through a laptop?

Thanks

yes..message length requires the cosessions software on a pc of some sort