sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems Busy Lamp/ICM Buttons

Can anyone explain a method to program Busy Lamp buttons that also act as a Intercom button too.

It's not apparently clear in 4-12 of the programming guide.

Thanks very much,

m.b. 4-12 prog. key as a "feature access" (example, FA 01)
then go out of prog. mode, and (w/out picking up the phone) press feature, the FA key you just programed, then 1 and the ext. number you want the key to represent and then feature key again. good luck.

------------------
www.tgcommunications.net

[This message has been edited by tom@tgcomm (edited July 07, 2005).]

This area of the programming is very confusing.

Let me clear up a few questions I have.

The Port/CO is for the extension I'm programming, right?

The Line Key represents the LK key I'm attempting to program FA for, right?

I go into programming mode, LK4-12. Press CNF until I get to the port number. Dial 03 to represent the Line Key three (third from top left) I wish to program. I then press the LK6 button for FA. The display shows FA to the right of the display. I type 01 and the display then shows FA 01. I hit transfer, Ans, and go out of programming. When I try to hit Feature and the LK3 button, it says UNUSED.

I must be doing something wrong.

email me w/a contact # and i will help you via phone.

you are. you're mising 1 little step that tom forgot to tell you.

you do :
feature
redial
button
1
the ext you want on that button
feature

Chris, I do this stuff w/out thinking about it when the phone is in front of me, but when I have to type it on a post I loose it. Tom

------------------
www.tgcommunications.net

Thank you both. I'm doing quite well now. Just a couple of issues that I'm trying to work out.

hey........i get a brain fart too sometimes!

no problem!