sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems 2000 IPS SL ports

I need to supply direct DT off of SL ports for faxes, modems and cc machines and have not found a way to do it yet. The system is PRI supported. Can anyone assist?

You mean analog ports off of an IPS? Don't you just put in an analog card?

Or do you mean that you want a specific trunk to answer at a fax machine? You can assign DILs (Direct-Inward-Lines).

Or do you mean that on out-dialing, you want to use a specific trunk for certain devices, perhaps without an access code? You can do that in LCR.

Not being a smart-aleck; I just don't understand your post.

I have no problem directing inbound calls to the devices and since there is currently only one route for outbound and one for emergency but can build another group for these devices if necessary to correct this issue. I am wanting to directly access lines for outbound calls without dialing an access code. Sorry to be unclear on the description.

Assign FAX, Modem, ect in the separate tenant CM1204.
Provide individaul Numbering Plan for this tenant CM29>xx:713.
Now in CM20
CM203>0:A129 - LCR 3
CM203>1:A129 - LCR 3
--------------------
CM203>9:A129 - LCR 3
write all first digits for local/toll call.
CM8AA000>3:4007
CM857>0: - length dialed number
CM857>1: - length dialed number
--------------------------------
CM857>9: - length dialed number

CM8A4007>0:Route Pattern
CM8A4007>1:Route Pattern
-------------------------
CM8A4007>9:Route Pattern
ect