sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems CNF(8)-U10

I would appreciate some guidance in programing a CNF(8)-U10 in an IPK with 4.6 Firmware. According to the manual the CNF installs as an SLI(8); however, you can select either SLI(8) or CNF(8)in the SAT program. Which is best? What additional programing is required? SAT doesn't have a Wizzard for the CNF. Is the procedure in setting up a conference any different than the base conference capability of the IPK?

Thanks

on the very few that i have done, which is done via a phone, i set it for esi8.

there is a little sheet you can get from nec's web site (if you are a certified tech) that has the programming steps. should have also come with the card if i remember right.

I've always set them up as an SLi8 with a circular hunt pattern. Main problem I've had is the low level of system prompts even after the cust has re-recorded them..

The CNF-8 must be set as a SLI-8, with mem blocks 4-31 for voice mail disconnect & 4-14 & 15 for hunt group asignment.

paulw & ipk2 are right......sli8 NOT esi8.

1>Assign the CNF(8)-10 ETU as SLI(8)-U10 ETU using
Memory Block 7-1 (Card Interface Slot Assignment).

2>All ports that are set to the same conference group should be set to the same Master Hunt Group using Memory Blocks 4-14 (Intercom Master Hunt Number Selection) and 4-15 (Intercom Master Hunt Number Forward Assignment).

3>When CNF is set for two, 4-party conferences, ports 1~4 should be set to the same Master Hunt Group, and ports 5~8 should be set to a different Master Hunt Group.

4>DIT assignment may be set to Master Hunt Group using Memory Blocks 3-42 (DIT Assignment) for day or 3-43 (ANA Assignment) for night.

5>All ports should be assigned as a Voice Mail Port by using Memory Block 4-35 (Voice Mail/SLT Selection) to insure proper disconnect signals.