atcomsystems.ca/forum Forums TDM Business Telephone Systems NEC Telephones & Systems ipkII remote programming?

I was wondering if someone could explain the procedure of remote access using the ipkII using the internal modem. I have read some documentation that says you need to transfer to a default extension to get a connection, but can't find anything saying what this extension is. Any help is greatly appreciated.

You can connect to the IPK II vie the WAN for remote programming.

11-15-01 default = 730 so you can point a DID or DIL to 730 for you "modem" RDA access.
yes you can set up remote access over the WAN ( or Internet ) you just need to re-direct port 8000 ( 90-38-02 ) to the IP address of you IPK II CPU , make sure you have the default router IP in your 10-12-xx series.... You can always redirect port 80 as well but if you are connecting it to the internet i would highly advise against that as every one has a web browser and not every one has PCPro . Just a *little* security.

Easiest way is to set up a VPN and connect to your customer's network remotely this way. Then you will have access to the Phone System and the Voice Mail with one connection.

D

One IP address for both phone and voice mail, only if customer has Inmail, Elite mail LX has its own IP address.

740 is the extension number for the MOD-U-10 on the CPUII, which, is optional equipment.

740? 730 is the default in Australia , must be different else where?.. just check that 11-15-01

In our systems, 740 is called modem access & 730 is called remote maintenance, however, only 740 works.