|
Joined: Apr 2010
Posts: 1
Member
|
OP
Member
Joined: Apr 2010
Posts: 1 |
We have a DS1000 with the expansion card and 4 lines originally. There are 2 other lines which originally went to analog devices. We decided to move these 2 lines onto the DS1000 and use analog extensions for the devices instead. I connected the lines to the DS1000's 5th & 6th trunk ports then programmed the same as the other 4 trunks. (via Use Program 1001, 1002 & 1003) The new lines are not ringing into the DS1000 and when I access the trunks, instead of a dial tone I get a busy signal. (The lines work fine if I attach a single line phone directly.)
What did I miss on programming the new trunks or what's the proper procedure to add a new line on the DS1000?
Thanks in advance.
|
|
|
|
Joined: Apr 2005
Posts: 2,485 Likes: 1
Member
|
Member
Joined: Apr 2005
Posts: 2,485 Likes: 1 |
Check 1803 (trunk access), 1805 (ring assignment). 1701 (function key)
We get old too soon, smart too late
|
|
|
|
Joined: Nov 2007
Posts: 369
Member
|
Member
Joined: Nov 2007
Posts: 369 |
Check the cable/cord at the KSU for trunks 4, 5, 6. It should be a 6-pin modular plug with 3-pair cable/cord. Line 4 wires to pins 3 & 4 of the modular plug, line 5 wires to pins 2 & 5, line 6 wires to pins 1 & 6. It sounds like you're not getting dial tone into the KSU trunk ports.
"I didn't do it, and I won't do it again"
|
|
|
Forums84
Topics93,878
Posts636,997
Members49,671
|
Most Online5,661 May 23rd, 2018
|
|
|
|