sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems NEC DSX Door Box I am Stumped!!

I have a DSX 80 that we installed a NEC controller and door box.The door box and controller came for another site where it was working fine.

What is happening at the new site is when you press the button on the door box, nothing happens. You can call the door box from a phone and all works fine.
If we short the wire at the door box (simulating like we are pressing the button)The phones ring, and we have communication to the door box.

Okay, that says to me that my wire going to the controller is good, my controller is good, the digital port the controller is wired to is good and my programming is good.

So we condemn the door box and order another one, we go back to the site, install the new door box and have the same problem. :shrug:

I have the tech bring the new door box back to the office and I use a multi-tester to check and see if I get a short across the two terminals when I press the door box button. The test shows that I indeed get a short across the two terminals when the button is pressed.

What am I missing here????

Thanks

Walter

Did you program the door box to work with the DSX?
You do know that there is programming involved for the door box to work properly.

TJ,
read my post again, the answer to your question is there.

I don't get this :shrug:

Make sure phones you want to ring are in same ring group, not rg 0. Had the same issue awhile back and that was the deal.

Tip and ring sensitive?

I was thinking the same, but into today's world diodes solve that, plus there is no mention of that in the manual.

Good call though with what I posted, definitely see you are a good and smart tech.

On the Aspire and I-Series door boxes they are tip/ring sensitive for sure.

Don't ignor jkinkler's post.

Amen Mr. jkinkler, like i stated programming.

I was thinking that with the test we did (shorting the wires at the door box) shows that the controller is programmed properly. When we throw a temporary short across terminals - and I at the door box, all the phones assigned in ring group 1 ring and there is two way communications.

Does that not prove that the controller is programed properly?

According to my tech and the manual, the phone system automatically IDs the port the controller is plugged into as a door box, this is verified when the tech looks at the port in programming.

As mentioned above, he programmed the door box in the same ring group as the phones the client wants to ring (ring group 1)

The only other programming I see is 2101-04, "door chime selection" and by default that is set to zero. So no programming there.

Am I missing something ??

Thanks