sundance-communications.com/forum Forums TDM Business Telephone Systems Comdial Telephones & Systems comdial executech "cordless"

In our office we have a executech model no616 and we want to install a cordless into our system but it has to be digital not anolog! is there any options so we dont have put it before our system? Any info would be helpful!!!!

in short...No
No options what so ever on the Executech for single line capability.

I would suggest a 900 mhz cordless phone that’s installed in front of your system. There might be others too, I'm not that familiar with the cordless arena. Others will post.

Sorry to disagree with you test-ok.The no616 can support single line phones thru a OPX unit. You need to program the port as a OPX Unit in program 61(Port Definition). You can then use it to dial out or intercom.



[This message has been edited by dtmf (edited December 19, 2002).]

I didn't think they worked with the NO series.
I hope they do for westwoods sake.
dtmf knows a lot more about the inter workings than I do so don't listen to me.
sorry for the mis information

could you please send me all info i need to do this? thank you!!!!!

Do you have a manual?
What you have to do is wire it for single line device,change port to OPX, when you change the port type it will automaticly assign it intercom access when you go off hook, so you will need to assign it Idle Line Pref. then you can have it grab a free line when you go off hook. Then you use the Flash to put call on hold and get intercom to trans. I will need your fax number to send the programming.



[This message has been edited by dtmf (edited December 19, 2002).]

i cant find the right manual. my fax # (218)694-6119! thank you very much!!!

You should have the programs on your fax.
Good luck

what type of cordless phone do i have to use? call me if you can #1-800-793-3492 my name is curt