sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Comdial Telephones & Systems DSUII Experience needed

I added a 408 expansion unit to my DSUII.

The added extentions work fine but the additional CO lines are only seen by the phones that are connected to the expansion unit.(stations 18-26)

Is the a way to program on station 10 so stations 10-26 can see all 8 CO lines.

Thanks

------------------

Yes you can add lines to the existing phones thru programming from extension 10.

Unfortunately, you will need the password to enter into the programmnig mode. There is a default, but this may have been changed by an old administrator.

Do you have the login information? If you do I or someone else will post the steps to add the lines.

2wire

Yes you can program the system from station 10 or 12, use program 56 then 02 for line button or program 56 then 13 if your using groups.

[This message has been edited by dtmf (edited December 15, 2004).]

Wow that was fast!

You guy's are great!!!

I called a local phone company and they wanted to send a sales rep to over view the problem in two weeks then schedual a tech to due the change... Wow... My boss freaked when he found how long it was going to take.

Thanks again..

------------------

Did you get it programmed?

Yes I got all the lines mapped!!!

The only weird thing is that only two phones rings on all the CO lines..


Thanks

------------------

that's also programming 54 and 1 for day I believe. Check that if you have a manual, if not I'll look it up for you.
mark

Yes it's 54 and 1 for direct and 2 for delay

Yup.. It's 54 1 for direct.

Now all phones ring with the new CO lines.


Thanks again......

------------------