Business Phone Systems

Previous Thread
Next Thread
Print Thread
Rate Thread
Joined: Jan 2005
Posts: 1
pproulx Offline OP
Member
OP Offline
Member
Joined: Jan 2005
Posts: 1
I am attempting to use an external modem to program the Corprate Office DX through com port 2. After succesfully connecting when I disconnect the DX board starts beeping and I can't reconnect until I reboot the system or disconnect and reconnect the cable. I am think that I need to jumper something on the cable to keep a signal present or eliminate a signal?

Thanks;
Peter

Atcom VoIP Demo
VoIP Demo
Joined: Oct 2001
Posts: 6,160
Member
Offline
Member
Joined: Oct 2001
Posts: 6,160
It sounds as though you are shutting down the VM program when you exit. When your done programming, returm to "display line status" screen and just x out of key link, then disconnect. If you use "exit this program", you shut off the VM software.
Mark


[This message has been edited by markk (edited January 26, 2005).]


Link Copied to Clipboard
Forum Statistics
Forums84
Topics93,879
Posts637,001
Members49,673
Most Online5,661
May 23rd, 2018
Popular Topics(Views)
Today's Birthdays
farhanrashid, gishymoto, John326, kisa, russ75707, tcullen
Newest Members
APInc, m1cashman, jonnycom, XJR9000, BitBang
49,673 Registered Users
Top Posters(30 Days)
Toner 10
teleco 6
dexman 5
jsaad 5
tim10 4
Shahza 4
Who's Online Now
0 members (), 83 guests, and 51 robots.
Key: Admin, Global Mod, Mod
Contact Us | Sponsored by Atcom: Business Phone Systems | Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers.
©Copyright Sundance Communications 1998-2023
Powered by UBB.threads™ PHP Forum Software 7.7.5