atcomsystems.ca/forum Forums TDM Business Telephone Systems Samsung Telephones & Systems IDCS 100 R2 and SIP Line

Hi all
I have iDCS 100 R2
MCP Version: 08.04.04 V2.75b
MGI3-8 Version: 06.10.10 V3.61
SCP Version: 08.04.17 V1.09

My SIP Provider is Unlimitel in Canada.
I try to dial out "8301" and number after, but i tell me "Busy" all the time.
Look this "SIP Server Options" and tell me if missing something.

GateWay Call ID : "My SIP Number"
CID Type : ANI
Default DIL Number : "My SIP Number"
UDP Port : Trunk : 5060
UDP Port : Phone : 5070
Retrans T1 Time (100ms) : 5
Retrans T2 Time (100ms) : 40
General Ring Time (100ms) : 50
Invite Ring Time (100ms) : 50
Provisional Time (100ms) : 1800
Inv. No Response Time (100ms) : 50
Retrans T4 Time (100ms) : 50
Signal Port : 10000
Send CLIP Table : 1
Incomming Mode : Follow TRK Ring
Gen. No Response Time (100ms) : 50
Request Retry Time (100ms) : 50
Allow GateWay IP Check : No
SIP Server Enable : Enable
Server IP Address : 209.217.98.194
REG Per User : Disable
SIP Server Port : 5060
Regist T-GW Number : "My SIP Number"
SIP Registered : No
GW Domain Name : sip02.unlimitel.ca
GW User ID : "My SIP Number"
Register Password : "My Password"
Register Expire Time(sec) : 0
Session Timer : None
Server Vendor : IETF
Link Test : None

Thank you for your help

REG Per User : Disable
SIP Registered : No

May be the reason your not getting tone. Other than that I dont thing the 100 has an scp card. You might want to "allow gateway check" aswell.

hi WRichey
Thank for your answer,
Is possible for me to enable the "REG Per Use" but is not allow me to change the "SIP Registered"
Do you know with is not allow me ?

Thank you

First you dont press 8301, you would press 8501. Second, you need a license on 2.75b. I'm assuming your "busy" is not just a busy signal. It should have a error message in the display. Out of service is displayed if you have no licence in 841.