sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Samsung Telephones & Systems MCP CheckSum Error

Has anybody done an upgrade that didn't work.

I upgraded the 7200 MCP Boot Rom to 1.07. Then started to upgrade the LCP & MCP. LCP went to 4.17 without problems but when it came to the MCP 4.14, the system would no longer boot up. Looking at the MCP via Hyperterminal I got the following error

[Boot PGM] <<< Boot Program of OfficeServ 500/7200 System >>> V1.07:2007/058
cpld = 00, bit_flag = 0000
cpld = 00, bit_flag = 0000
cpld = 00, bit_flag = 0000
[Boot PGM] This board is for MMC memory card.
... Card is formatted with FAT16
... Manufacturer: SEC
... Application : Valid OEM ID
... Product Name: 000000
... Capacity: 61Mbyte (64225280)
... Transfer Speed: 20.0MHz

[Boot PGM] pass ... InitializeMmcController()

[Boot PGM] To be display '#' mark every 128K byte loading to DRAM
|1%
####[O.K]
[Boot PGM] load file Check sum is O.K, Origin CheckSum:1873, loaded CheckSum:e
[Boot PGM] Success to the loading to DRAM
[Boot PGM] Now start Startup Program of OfficeServ500/7200 System

[Startup PGM] !!!Warning: There are No assigned IP Configuration (Default IP Ad)


[Startup PGM] <<< Startup Program of OfficeServ 500/7200 System >>> V1.08:28
cpld = 00, bit_flag = 0000
cpld = 00, bit_flag = 0000
cpld = 00, bit_flag = 0000
[Startup PGM] This board is for MMC memory card.
... Card is formatted with FAT16
... Manufacturer: SEC
... Application : Valid OEM ID
... Product Name: 000000
... Capacity: 61Mbyte (64225280)
... Transfer Speed: 20.0MHz

[Startup PGM] pass ... InitializeMmcController()

[Startup PGM] Success to the getting mcp file(MPPSV414.ZPG), try to loading toM
[Startup PGM] Because mcp file(MPPSV414.ZPG) is zip file, need to decompress af!

[Startup PGM] To be display '#' mark every 128K byte loading to DRAM
|1%
#############################
[Startup PGM] load file Check sum is Error, Origin CheckSum:FE81, loaded Chec

Have reloaded the Boot Rom & tried v2.67, v2.69 & v4.11 but nothing works.

Spoke to our tech support (not directley to samsung) they recommended switching on dip switch 5, but still nothing.

Anybody have any ideas how I can get it to work without sending the card back.

why 4.14 why not 4.30

I had tried 4.30, with the same result. I only captured the 4.14 start up.

Have you tried booting with battery off?

Yes. I've run out of ideas. The next step would be to hit it with a hammer.

Want to borrow my hammer. Have you another system that you could copy all and try to install on the card or buy a new card or mcp

I have 2 new systems on order but our suppliers dont have any in stock at the moment.