sundance-communications.com/forum Forums Wiring - Telecom Carriers - Trunks & Services Cabling Telephones Systems Wiring who sets up the 66 blocks?

Crimping mod ends on those cables essentially turns them into patch cables. Patch cables eventually fail and need to be thrown out and replaced. You don't want to treat your structured cabling like a bunch of patch cables.

Treat your structured cabling and terminations like a permanent fixture. Once the cables have been terminated, you shouldn't have to move them around or plug them into anything. That's what jumper wire is for.

I still stand by my advice to let a professional do your terminations. If you're looking for shortcuts rather than just following grider's instructions, then you're probably coming to the same conclusion by now. Honestly, there is no shame in not doing the terminations yourself. I teach a cabling course, and I cannot think of too many students who could do the lab work based only on reading descriptions of how to do it. Not without butchering the job anyways. If you really want to learn how to do this, you need someone to physically show you how. Every situation is a little bit different, and only someone with experience is going to know how best to deal with your exact situation.

Hi Grider, from your tutorial, I think I understand terminating the 66 block. I was wondering about what those 66 blocks are for.

Thank you.

I want to make sure I understand it correctly.

On the left side of the 66 block. Cable 1 to 6. Untwist and Punch down each twisted pair on the left most clip. Blue, Orange, Green and Brown pairs

On the right side, continue with cable 7-12, do the same thing on the right most clip.

I would need 3 66 blocks for 25 cables. For the cabling job, is this all I have to do?

I know how to terminate to a Patch Panel for cat5e cabling. I was getting confuse because mainly this is the first time I am doing telephone caling.

Thanks Gridger. You love your coffee, is there a particular brand/favor you like? Starbucks?
Have a nice day all.

Those 66 blocks that you mentioned are pretty much for terminating station cables with a jack on each end. The fact that the equipment end is on this block just makes it go a little faster. You would then run patch cords from each jack on the block to the corresponding jacks on the system (i.e: Panasonic, Partner, Comdial DX80). This is not the most preferred way to do things since you are basically committing the wiring system to one particular family of systems.

You should terminate the cables from top to bottom down one side using a standard 66M1-50 block. It's OK to stack these blocks vertically. If you choose to do this, the left side of the lower block becomes cables 7-12; the upper-right of the top block becomes cables 13-18 and so on.

This would end up leaving you with a single cable on the third block, but that's OK. You need to leave additional block space for future cable runs. For the third block, make sure to leave the width of a block between them horizontally (about 3") for jumper routing. Better yet, use a factory backboard (183A1 for example) which will provide 89-type brackets that are spaced in a uniform manner.

Using standard 66M1-50 blocks also leaves your installation more universal, meaning that any system can be connected to your wiring with ease. Simple cross-connect wiring affords much more flexibility in the long run. Using pre-terminated blocks that contain jacks are really not the way you want to go.

Starbucks sells easy to mail gift certificates. Do you need my address?