atcomsystems.ca/forum Forums TDM Business Telephone Systems Toshiba Telephones & Systems speed dial station

is the anyone who can help me setup a flexible button assignment?
i have run program 38, 39 to setup 20 button system and i would like to use the speed dial station button. my system is dk40.
admin is on logical ports 000 station number 10.
i have tried to use directory number assignments, can someone give me an example how to set it up? all helps is very much appreciated, thank's a lot for your time and have a nice weekend.

You have 40 personal speed dial bins. In prog 39, assign *10-*49. Then just program whatever number you want on them.

i know its sounded dumb, but could you give me an example please? i have been trying to assign it but it only working as an alternate of intercom. lets say i am on the station number 10. i want to assign my lower right corner button to speed dial station 12. how do i assign it?

thank you so much for your help sir, and enjoy your weekend.

What you're trying to do isn't a speed dial, that's where the confusion might be with the previous answer.

I'm going from memory, but I believe it's either ##xxx or #xxx where the xxx is the port number of the phone you want to intercome. So if station 12 is port 002, you'd program the button as #002 (or ##002). Try them both, I forget which one it is. Use program 04 to make sure you're using the right port number.

thanks TheGreg666. i think its called Directory Number Button Assignments. have a nice weekend

#xxx will make it a DSS key allowing you to intercom that station and see if they are on the phone.
*12 will make it a speed dial button allowing you to dial an outside number programmed into personal bin#12. Remember to put a 9 in front of the number so it grabs a trunk.