|
|
Joined: Jun 2011
Posts: 19
Member
|
OP
Member
Joined: Jun 2011
Posts: 19 |
Every couple of months, I have to reseat a LSC because all 4 call buttons are lit up. Frustrated, I tried to figure out a way to reset the card remotely thru DBStudio. I went to the card and changed the 4 circuits from 'loop start' to none, and then back again. I didn't note the circuit id for each one and therefore went with the what it defaulted to. dialing '8' or pressing 'outgoing' gives me a line out, but now the buttons for call 1, 2, 3, 4 don't work nor light up when a line is in use. I checked 'CO Trunk Groups' etc by comparing with another site that I have and can't find any config differences. Any ideas what I missed? - Thanks, Greg
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: Jun 2011
Posts: 19
Member
|
OP
Member
Joined: Jun 2011
Posts: 19 |
I think I figured it out. The keyset/mapping was set to 8600. I have 8560/8520 models. mapped the call 1,2,3,4 to a call key.
|
|
|
Forums84
Topics94,294
Posts638,834
Members49,769
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
125
guests, and
347
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|