sundance-communications.com/forum Forums VOIP Phones & IP PBX Networking At&t spirit

I have a at&t spirit phone system in my shop
and the other day the touch pad Quit working and now it just like a rotary phonePlease help.I have a controller system# CS308A1.
Contact David Tribble 770926-5883
Thanks

Is it a 616 or 1224? You will need to go into Admin and look at the Dial Type for the lines.

>>I have a controller system# CS308A1.
Thats a 308 controller dtmf


SPIRIT CS administration may be carried out from either a 6-button or a 24-button set.
Three important steps are required for entering the administration mode:
1.The control unit ADMIN switch must be ON.

2.The administration overlay must be in place on station 10.

3.The set must be plugged into control unit jack 10 (call processing is interrupted only
at station 10).


DIAL TYPE
Press FEATURE. Dial 7.
Each line indicator light will show the current dialing type for that line. If the light is OFF,
that line is set for touch tone dialing. If the light is ON, the line is set for dial pulse
dialing. To change the dialing type for a line or lines, press the line button(s) and dial the
appropriate digit from the table below. YOU may press more than one line button to make
the change on more than one line. If you enter a digit without first pressing a line button
you will hear the error tone.
DIAL INDICATOR LIGHT SETTING
1 OFF Touch Tone
2 ON Dial Pulse (installed)

added:
You now have it in pulse what you want is tone. If I read your post correct.
let us know if it works?

[This message has been edited by test-ok (edited May 18, 2004).]

oh and then turn the admin switch back off.

Duh, I guess if I would have looked at the # I would have figured that out.

You may need a couple more steps after moving the admin switch, and before dialing Ftr 7


1.From station 10 press intercom
2.Press speaker
3.Dial *0
4.Dial 1
5.Then Press Ftr 7

****Step 4. is where you need to be careful if you enter a "0" there instead of a "1", it will default the system if it is not defaulted already.

[This message has been edited by JOHNYREB (edited May 18, 2004).]

Sounds like it already defaulted bieng that it went back to pulse. I can fax you the Program page and the overlay if you would like, they are not hard to program at all.

[This message has been edited by dtmf (edited May 18, 2004).]

you can also call that dtmf and he can explain it too. click on his profiles (the little man with a ? mark)

I had to switch out a spirit KSU its a 308 with a 308 expansion, all works fine but it pulse dials not tone. I slide the admin switch to admin then hit the intercom then speaker then *0 hear 2/3 beeps then hit feature and got error tone, hit 7 got error tone try hitting line 1 and error slide the admin switch back and still pulse dials help what did I do wrong
Neil

Probably tagging on to a 10 year old thread for starters. Best to start a new topic as many don't follow old threads plus it helps with search results.