|
|
|
|
Joined: Jul 2004
Posts: 291
Member
|
|
Member
Joined: Jul 2004
Posts: 291 |
Hey guys...Another quick question. This is from my Ctrl C , H screen.
LOOPBACK ENABLED is new to me. How did i do that and how do i make it go away ?
REVISION: D4.119 DATE: Fri 02-02-18 07:07 a [A]SSIGN 2 SLOTS N
ALARM STATUS: 14
BPV STATUS: 00 [V]OLUME 09
LOOPBACK ENABLED
MISC. INFO MSG_in: 525 MSG_out: 827 Board Reset[s]: 6
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
|
Joined: Dec 2008
Posts: 280
Member
|
|
Member
Joined: Dec 2008
Posts: 280 |
That is the T1/PRI monitor screen it shows the activity on the different channels and if it is in an alarm status the state changes. 14 is good I don't see where it says loop back enabled
perhaps it just saw a loop back condition at one time. About the only thing you can do in that screen is hit Space bar to refresh. Or hit R then it will ask channel to reset. (Never used that) but if you type in 33
and hit enter it resets the card. Of course it drops all calls during reset. Then wait a few and hit space bar to refresh or go out and back into screen.
Can't remember what manual I sent you but the codes are explained on pg 33 of older manual and pg 94 of the Eclipse manual.
If working all good.
mjc
|
|
|
|
Forums84
Topics94,515
Posts639,962
Members49,847
| |
Most Online5,661
May 23rd, 2018
|
|
|
2 members (PhoneGuy827, Yoda),
141
guests, and
46
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
