sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems NEC Telephones & Systems NEC SV9100 call rejection based on incoming caller ID

NEC SV9100 with Comcast DID PRI, caller ID programmed on all trunks and functional

System programmed using the following reference;

To reject the call with "XXX-XXX-XXXX" Caller ID incoming call
Program 14-01-27: 1 (reject) - set
Program 22-16: 64 (ABB group 64) - set as 64
Program 13-02; Group 64: 1000 - 1099 - set as 1000-1099
Program 13-04-01; Table 1000: XXX-XXX-XXXX, set last 1099 as the number I want to block (I'm working backwards 1099 to 1000)
Program 13-04-03; Internal Transfer, set
Program 13-04-05; EXT 9999, set as a VRT with no call forward in 24-09 so I just want it to ring away
Then turn on the Caller ID Refuse mode using the service code (Program 11-10-34), set we are using 699 as the code to turn on or off

When the PRI is called using the XXX-XXX-XXXX telephone (a cell) calls are still ringing through to the Operators extension.

What am I missing? Why can't I block am inbound call based on Caller ID?

I sent you a private message, let me know how it works.

I'm pretty sure I have done this in the past and all I did was forward it to a number that didn't exist and they get a busy. For sure you could setup one VE to a routing mailbox with a second of silence and set the DAT to hang up.

If DIDs are pointed in 22-11 to ring an EXT, does 22-11 stop the system from recognizing callerID inbound 1st?

CID goes before routing.

Have it set just they way everyone has described and using my cell inbound as a test...call still goes through.

Caller ID is only 10 digits.

22-11-11 must be turned off on all tables using it.