sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Samsung Telephones & Systems OfficeServ 100 CO lines wiring

Not sure if i am reading this correctly.
the Manual Shows CO lines connecting to P2 Amphenol.
The 6 trunk card is in Slot 3. Does that make Yellow-Orange
the tip and ring. CO Trunk 13?
When i try to put a button on a key for dt13, i get error tone
right away. Do i need to enable the trunk somewhere?

Thanks
Doug

Trunk 13 key would be dt713.
Assuming you have preinstalled the card and numbeted in it mmc724

What other trunk cards do you have in the system?
I'm assuming 2 x 6trk 1 each in slot 1 and 2?
Iirc pair 24 would be the first trunk I that card in that slot.

Let's start by listing what cards you have and the slot order they are in.

Basically, in the main cabinet the first amphenol will be the 8 built in digital ports on the motherboard and the various moh, page and auxillary connections. P2 will be 8 pairs for each slot so slot 3 will start at pair 17 which yes y/o .If that is the first co card then by default that would be trunk 1 or 701 in the dialling plan. y/g would be trunk 2 or 702

That is what I was missing that it would be 701 even if the card was in the third slot...

Thanks guys

Doug

I had 8 digital in slot 1
SVMi-4e in 2
6 CO card in 3

i changed 3 & 1 and reassigned them in 806.
I will put them back and take system to office
so i can watch the dialing strings on the port screen.
for auto attendant routing.

That is what I was missing that it would be 701 even if the card was in the third slot...

Thanks guys

Doug

I had 8 digital in slot 1
SVMi-4e in 2
6 CO card in 3

i changed 3 & 1 and reassigned them in 806.
I will put them back and take system to office
so i can watch the dialing strings on the port screen.
for auto attendant routing.

Thanks that worked great.