|
Joined: Jul 2001
Posts: 30
Member
|
Member
Joined: Jul 2001
Posts: 30 |
I'm trying to install A Pri circuit in a Definity BCS system,and i'm stuck
I installed DS1 board, programmed ds1 slot, setup trunk gr for PRI, and installed signal-group as the 01b**24 and assignned the trunk group to the sig. gr. but the pri. company still does not see my switch an advise would be greatly appreciated.
|
|
|
|
Joined: Jul 2001
Posts: 126
Member
|
Member
Joined: Jul 2001
Posts: 126 |
You did not mention this, but did you set up the communications-link? I hope this helps.
|
|
|
|
Joined: Aug 2001
Posts: 21
Member
|
Member
Joined: Aug 2001
Posts: 21 |
Did you set up clocking and the rest of the Pri data. If you have, have you done a loop back from the csu to the provider to see if they see they're signal and have you down a loop back on your's to see if it will bring it's self up.
|
|
|
|
Joined: Jul 2001
Posts: 126
Member
|
Member
Joined: Jul 2001
Posts: 126 |
Just another thought. Did you status the trunk group to see if the PRI is OOS-FE or OOS-NE. If it is FE (out-of-service far end) the provider should double check there circuit, as well as you for proper configuration.
|
|
|
|
Joined: Mar 2001
Posts: 7,350
RIP Admin
|
RIP Admin
Joined: Mar 2001
Posts: 7,350 |
The advise above is all good Kwikwire, The most important is to loop back. Nine times out of ten it's the provider. You might want to test with a tech from your T1 provider and make sure all your settings are matched, take your time and go over all of them, then try a loop back.
Russ runs a local service and private tech center. ![[Linked Image from sundance-communications.com]](https://www.sundance-communications.com/installers/logos/65graphic.jpg) [/url]
|
|
|
|
Joined: Feb 2002
Posts: 1
Member
|
Member
Joined: Feb 2002
Posts: 1 |
I install a hardwired loop back plug or jack (RJ48X) as close to my equipment as possible. Then I have the vendor do a loop back test. If this test is good but the circuit still fails when reconnect I find that in 50% of my T-1 installs that the Transmit and Receive pairs are reversed.
|
|
|
|
Joined: Mar 2002
Posts: 179
Member
|
Member
Joined: Mar 2002
Posts: 179 |
can you do a list config all and paste it here?, and also info on the framing and suppression?, what type of csu are you using?, are you using CBC or public-network?
|
|
|
Forums84
Topics94,513
Posts639,935
Members49,844
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
144
guests, and
42
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|