|
|
Joined: Mar 2001
Posts: 5
Member
|
|
Member
Joined: Mar 2001
Posts: 5 |
I've looked in every manual there is for
the Legend and can't find the pinouts from
the card for Simplex use. Any help out there.
|
|
|
|
|
Joined: Mar 2002
Posts: 179
Member
|
|
Member
Joined: Mar 2002
Posts: 179 |
The 400 e/m tie card is a 6 wire standard tie trunk card. you have to use 6 wire to make it function. I'm not sure of the wiring? you might want to check with a tech web site that has that type of wire codes posted.
|
|
|
|
|
Joined: Mar 2002
Posts: 117
Member
|
|
Member
Joined: Mar 2002
Posts: 117 |
The Legend R6.1 Installation manual has a section on this card that explains the DIP switch settings for the card depending on what you are using it for. It can be used in Simplex mode and use standard 4 wire. Signaling rides on analog pairs. You can download this manual off of Avaya site. It does not have the pin out. Typically your 1st pair is RX, 2nd is TX, 3rd is signalling.
So 4,5 is RX 3,6 is TX and 2,7 E/M
Your service provider should outline delivery of service. It is provisioned as a tie trunk as Ken stated.
|
|
|
|
|
Joined: Mar 2002
Posts: 117
Member
|
|
Member
Joined: Mar 2002
Posts: 117 |
I got it!! I dug deep into the archive!
Pin out is as follows: pin1-Tip1 RX, Pin2-Ring1 RX, Pin3-E Lead, Pin4-Ring TX, Pin5-Tip TX, Pin6-M Lead, Pin 7&8 not used.
|
|
|
|
|
Joined: Mar 2002
Posts: 179
Member
|
|
Member
Joined: Mar 2002
Posts: 179 |
I was told by Tier 3 that if you want to use this 400 card for true e/m tie, it has to be wired as 6 wires, otherwise it's just simplex, like a did trunk.
|
|
|
|
|
Joined: Mar 2001
Posts: 5
Member
|
|
Member
Joined: Mar 2001
Posts: 5 |
Thank You All for the info.
Did Tier 3 tell you how to wire out of the
400e&m card for simplex..still uses 2 pair.
Using the 3 pair pinout I got the switches
to talk to each other. If I can get the
simplex (2)pair pinout...that would make my
day.
Thanks..Dan
|
|
|
|
|
Joined: Mar 2002
Posts: 117
Member
|
|
Member
Joined: Mar 2002
Posts: 117 |
According to the simplex description, it states that you use the standard four wire pinout. I would assume that the pinout I gave you would stay the same. Don't use the E and M pins. You have to set the jumpers on the ports for simplex mode. Those settings are referenced in R6.1 installation guide. Check the index for 400 E&M strappping.
|
|
|
|
Forums84
Topics94,552
Posts640,109
Members49,861
| |
Most Online5,661
May 23rd, 2018
|
|
|
2 members (BobRobert, justbill),
122
guests, and
211
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
