A8 is not correct I need the layout of CCH# points to site #. What is needed is that all point codes are defined in each switch. in command A8.
"However, when I made the change site 5 became an Island and couldn't connect to attached sites 1, 6, & 8."
Do you mean no calls or no records. If no calls I ve seen this before and what fixed that was a reset at the main.
"*As far as CMD016 being the same as sites 3 & 5, I'm a little leery making changes being that Site 1 is the Center Office, is this wrong?"
With D016 set in sites 3&5 that way they are requesting call records that the main is not.
------------------
Hot Rod
