I have a kinda unique situation with 2 phone systems I help maintain. At our main location(A) we are using an IDS 228(I think that's the number). We then have a point to point t1 to a second IDS 228 at an offsite location(b). The phones from B are set for TIE connections, so that all calls from site B go through site A, allowing for extension dialing between the 2 locations. The problem arrises when someone at site B dials 911, the call shows up as originating from site A. I was instructed(by Executone tech) that I needed to add a GS card and connect a copper line to it and then use LCR to program a second service to dial 911 through the second service(copper). I connected the copper line to the first port on the GS card and set it so that dialing 911 will send it out on that line. When dialed, however, it just stalls. In the F screen, it shows that the line is active, but it doesn't dial. I was thinking maybe I had the copper line to the GS card screwed up or something. Any ideas or knowledge on how this is supposed to work? Thanks!