I am installing a Axxess system with 4.4 software. currently its setup with two POTS lines on a LSC card, and a 23 B channels on the PRI.
The Telco turn up the B channels this morning, incomming calls work no problem, but I can not place any outgoing calls on the PRI.
when I try to grab trunk group 9202, which is the one that has the B channels I get a busy signal.
The Telco, is telling me I am not passing them any digits to be dialed. here is a sample from the switch station logs froma test ran this afternoon..
<== 01:15:11:00.82 (CM Time: 26:16:28:52.98).
<== Q931: SETUP: from S[7044] L[1,538,0] E[175,537,0] SPA[----]
CR: 0,00 04
BC: speech
64 kbit/s
circuit mode
mu-law speech
CID: 18
LENGTH: 03
Channel Selection Info: As Indicated in Following Octets
D-Channel Indicator: D-Channel NOT indicated
Preferred/Exclusive: Exclusive
Interface type = primary rate
Interface Identifier: IID Implicitly Identified
Channel Type: B - Channel Units (3).
Number Map: Channel is indicated by the number following.
Coding Standard: CCITT
Channel Number = 15
CDN: e164
local_directory_number
==> 01:15:11:00.86 (CM Time: 26:16:28:53.02).
==> Q931: REL COM: to S[7044] L[1,538,0] E[175,537,0] SPA[----]
CR: 1,00 04
CSE: public_network_serving_local_user
destination_address_missing/non_existent_cug
the PRI is a NI2 on a DMS100 switch, passing 4 digits for the DNIS
I have checked to Make sure the stations are set for outgoing access on trunk 9202.
Something is telling me I am overlooking a minor detail in the programing but i have check everything i know to check. but i am limited in knowledge on the programming side of the axxess.. some areas that i am wondering about where i could have made a mistake, is the toll restriction feature? and ARS???
