sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Inter-Tel Telephones & Systems No outgoing calls.... on a new PRI

I am installing a Axxess system with 4.4 software. currently its setup with two POTS lines on a LSC card, and a 23 B channels on the PRI.

The Telco turn up the B channels this morning, incomming calls work no problem, but I can not place any outgoing calls on the PRI.

when I try to grab trunk group 9202, which is the one that has the B channels I get a busy signal.

The Telco, is telling me I am not passing them any digits to be dialed. here is a sample from the switch station logs froma test ran this afternoon..

<== 01:15:11:00.82 (CM Time: 26:16:28:52.98).



<== Q931: SETUP: from S[7044] L[1,538,0] E[175,537,0] SPA[----]

CR: 0,00 04

BC: speech

64 kbit/s

circuit mode

mu-law speech

CID: 18

LENGTH: 03



Channel Selection Info: As Indicated in Following Octets

D-Channel Indicator: D-Channel NOT indicated

Preferred/Exclusive: Exclusive

Interface type = primary rate



Interface Identifier: IID Implicitly Identified

Channel Type: B - Channel Units (3).



Number Map: Channel is indicated by the number following.

Coding Standard: CCITT

Channel Number = 15

CDN: e164

local_directory_number









==> 01:15:11:00.86 (CM Time: 26:16:28:53.02).



==> Q931: REL COM: to S[7044] L[1,538,0] E[175,537,0] SPA[----]

CR: 1,00 04

CSE: public_network_serving_local_user



destination_address_missing/non_existent_cug


the PRI is a NI2 on a DMS100 switch, passing 4 digits for the DNIS

I have checked to Make sure the stations are set for outgoing access on trunk 9202.

Something is telling me I am overlooking a minor detail in the programing but i have check everything i know to check. but i am limited in knowledge on the programming side of the axxess.. some areas that i am wondering about where i could have made a mistake, is the toll restriction feature? and ARS???

i'm no expert but there is a line stating "D-Channel NOT indicated" Did you check with Telco to insure they were sending it. also, you need a PRI Daughter board on the T1C in order to accept PRI from telco.